September 16, 2013
The cross-country phase is an exciting stage of flight training that pushes back the boundaries of your aviation universe, builds your endurance, and offers a taste of your aircraft’s capabilities as a traveling machine. Flights to varied destinations expose you to quiet strips or buzzing terminals—and may take you through numerous airspace classes. (For operations in Class B airspace and at airports located within Class B airspace, make sure you meet the requirements and possess required endorsements.)
Keep in mind that using pilotage to fly destinations in urban environments can present different challenges than selecting and locating checkpoints did on other cross-countries. And because the communications component of flights into busy airspace takes on critical importance now, you may have to locate the proper checkpoint and then report your position as precisely as possible.
That will take great skill and care, with all those buildings, railroads, highways, and interchanges down there. Suppose you are approaching your destination from the west and have been instructed to report at 10 miles west when over a specific highway. Can you tell the many roads apart as they weave their way through the urban sprawl?
One pilot who misinterpreted an assigned reporting point—an error that resulted in an airspace incursion—concluded that "being relatively new to the area and unfamiliar with the terrain and landmarks" contributed to the error, the pilot said in a report to the Aviation Safety Reporting System (ASRS).
What about weather conditions? A pilot noted the contrasting presentations of a chart and the view from the cockpit in this August 2003 Flight Training magazine article:
"The haze rendered many details shown on the sectional chart difficult to pick up until we were relatively close. And, much of the detail that was visible through the haze was not depicted on the sectional chart. For example, there were many more roads than were shown on the chart."
Studying aerial images and photos beforehand revealed “the true shape of the town, individual streets, identifiable buildings, parks, and baseball fields.”
Chapter 15 of the Pilot’s Handbook of Aeronautical Knowledge provides general guidance for selecting checkpoints, and introduces the technique called bracketing to keep you from straying from the desired track.
"If possible, select features that make useful boundaries or brackets on each side of the course, such as highways, rivers, railroads, and mountains," it says.
Safety and Education,
The FAA encourages pilots to do a number of things in order to increase safety, but does not require them. Check out these three actions that are recommended.
Among the very first lessons a pilot learns is that a control yoke is not a steering wheel. Research underway in Europe could change that.
Your CFII usually follows up route-planning drilling with a review of appropriate regulations, and today’s selection is 14 CFR 91.185, "IFR Operations: Two-way radio communications failure."
VOLUNTEER AT AN AOPA FLY-IN NEAR YOU!
SHARE YOUR PASSION. VOLUNTEER AT AN AOPA FLY-IN. CLICK TO LEARN MORE >>>
VOLUNTEER LOCALLY AT AOPA FLY-IN! CLICK TO LEARN MORE >>>
BE A PART OF THE FLY-IN VOLUNTEER CREW! CLICK TO LEARN MORE >>>